The NanoFoamer™ Pro is the only affordable alternative to a steam wand that produces real microfoam. Ideal for latte-art! The second Generation has a couple of improvements based on customer feedback.
The NanoFoamer is the ideal addition to a Flair espresso machine!
Get the same great results like the NanoFoamer, but fully automated. The NanoFoamer Pro both heats your milk (alternative) and creates microfoam.
With 5 presets and 3 flow controllers you'll be able to optimize the foam thickness and smoothness to your preferred mouthfeel and milk (alternative). Use the cold program for those textured summer drinks, your imagination is the only limitation.
Generation 2 new features:
1. ADJUSTABLE HEIGHT IMPELLER
The new impeller shaft features a revolutionary adjustment knob to raise or lower the impeller by 0.4mm (0.015") per click, allowing precise positioning of the impeller in the magnetic flux for a very quiet operation.
Note: In addition to finding the perfect balance, the impeller height can be used to finesse the microfoam. A lower impeller may be better for tiny drinks, as it will slightly reduce the foaming, while a high impeller might be ideal for stubborn milk alternatives.
2. FINER FOAM
The aeration time on P1 has reduced from 1 second to just 0.5 seconds. Blink, and you'll miss it, but now you can make even smaller drinks or finer foam for your flat whites. P2 has a reduced aeration time from 2 seconds to 1.4 seconds. P3,4,5 remain unchanged for the larger drinks.
3. IMPROVED VORTEX CONTROL
In the Gen-2, the impeller slows down twenty seconds into the microfoaming process to prevent the vortex from building too much momentum and accidentally re-aerating, ensuring it is always the finest it can be.
4. IMPROVED HEAT DISSIPATION
A thicker aluminium heat dissipation plate that wraps around the sides of the internal jug now reduces hot spots, prevents scalding, and makes cleaning a breeze. You can now make multiple drinks in a row with just a rinse.
5. IPX5 SPLASH RESISTANT
Using a new type of Strix brand kettle connector, the base has been sealed and completely splash- resistant, allowing it to be freely cleaned under running water without risk of damage. However, the NanoFoamer PRO should not be submerged or placed in the dishwasher.
6. INCREASED TOP TEMPERATURE
The first beep is now at 60°C (up from 55°) and the final top temperature is 70° (155°F).
7. SMALL TWEAKS
The lid fits on a little easier than our first generation and the NanoScreen has also been improved to make removal for cleaning easier. The little hole in the lid is slightly bigger so a kitchen thermometer can be placed in while running to check the temperature if needed.
Vaak gekozen accessoires: